Use the flat screwdriver to pop off the covers. Some of our top Alternator product brands are , and. You remove the front pass. Alternator also went bad which lead to new battery. Then do it in reverse to put it back together. Steps 1 thru 5 are exact.
Remove the alternator 2 bolts and 2 electrical connections 8. Attach a rachet to this bolt shape structure not the bolt and as you put pressure on this structure, the pulley will move. The tools you will need: A 2 Phillips head screwdriver. The last thing is to undo the bottom nut from the side closest to the exhaust under the alternator. I guess it depends on what year.
Back bolt on alternator is very difficult to install or remove, unless you have a complete mechanics toolset and a magnet to get it back in place, I would not attempt. Loosen the alternator lower mounting bolts. Shift radiator to side to make more room to get alternator out. When an alternator goes bad on any vehicle, it drains the battery of power. Disconnect the negative battery cable 2. Look at the pulley farthest from the alternator.
You may have missed a screw. Hear from other customers via the 285 reviews on parts for your Hyundai Accent. If you have power windows, you will have to unclip the wires going to the switch. This bolt has to be totally removed by pulling it out from the belt side. The fuel filter is under the back seat in my 2000 Accent. Please note: This alternator is built by one of two world-class vendors. If it's a solid light then there should be screws in front of the headlight that hold it in.
Service department still unable to resolve. One sensor is located under the brake master cy … linder, the other is on the front side of the transmission. If lights are on, it will drain even faster and you will notice the lights go dim until eventually the car dies. Disconnect the wire harness from the alternator electrical connections 4. It seems the more important of a part, the worse it is from advance auto part stores. First take out all of the screws in the door panel.
It was time for an oil change anyway, but just removing the filter only lost maybe half a quart of oil. Shouldn't be hard on any car. You just lift the seat with the tabs and under the seat is a little door. Reliance Road Assist Card - May 1 2014 Tired of replacing the same part over and over again? To remove the door panel, simply pull it off, starting at the bottom of the door and prying your fingers between the panel and the door. From bottom loosen pivot bolt. For the timing belt i'd say go get the haynes manual and don't forget the water pump while your in there.
To promote their longevity, each comes backed by a limited lifetime warranty. Everything has been maintained on a regular basis and I'm still losing gas mileage. If it doesn't come fairly easy, don't pull too hard. Once you loosen this you'll be in great shape. Addendum: Actually, if the… To remove the alternator, remove the top bolt that tensions the belt. Place a piece of cardboard over the rad so you dont mess it up when you pull the alternator out it is tight! I did this recently on Hyundai Accent. A new alternator for Hyundai Accent from AutoZone ensures that there's a constant flow of up to 14.
The seat is removed by pushing in the two plastic tabs in the front of the seat the tabs would be under your knees if you were sitting in the seat. It is though, a standard replaceable part much like water pumps, tuneup items etc. Over all I think I have paid for this car at least twice!. . Put radiator back in its place. If you hear nothing, or slow clicks, it's the alternator.