The fluid must also be thermally stable so that it can maintain a consistent viscosity through a large temperature range. X X Inspect the brake linings. X X Drain and refill the front and rear axle fluid. You will not be disappointed. X Replace the spark plugs. X Inspect the drive belt, replace if necessary. X X X Inspect the engine air cleaner filter, replace if necessary.
If you have any doubt about your ability to perform a service job, take your vehicle to a competent mechanic. X Drain and refill the front and rear axle fluid. X Miles 18,000 21,000 24,000 27,000 30,000 Kilometers 29 000 34 000 38 000 43 000 48 000 Change the engine oil and engine oil filter, if not replaced at 3 months. Remove hub bearing 3 from the steering knuckle. Tilting the top of the wheel inward provides negative camber.
Do only that service work for which you have the knowledge and the right equipment. Move the halfshaft to the side and support the halfshaft out of the way 4X4 only. Install the ball joint 4 into the control arm 3 and press in using special tools C-4212-F press 1 , 9654—1 Driver 5 and 9654—2 Receiver 2. X Inspect the drive belt, replace if necessary. After you have completed the repair, throw the pages away! X Drain and refill the front and rear axle fluid. Provide a suitable support to hang the caliper securely.
Mount a dial indicator solidly to the topside of the lower control arm and then zero the dial indicator. . छ X Replace the spark plugs. Loose or worn steering gear. X X Inspect the brake linings. X Clean and lubricate the brake caliper pins.
Loose or worn steering or suspension components. However, the very first time, Jeep also highlighted on-road efficiency to the same extent as the cornerstone of the brand name, off road ability. Grease smudges to the covers. X X X Inspect the engine air cleaner filter, replace if necessary. Rotate or replace tire as necessary.
X X X X Rotate the tires. X X X X X Rotate the tires. Install the caliper adaptor mounting bolts to 176 N·m 130 ft. Brand new the 2009 model year, Jeep Grand Cherokee features a new 5. X X Drain and refill the front and rear axle fluid. Disconnect the cruise control servo electrical connector.
The symbols correspond to the controls and displays that are located on the instrument panel. Loosen the tie rod jam nuts 3. A reversible load-floor panel was carpeted on a single part while offering easy-to-clean vinyl on the other side. X Inspect the drive belt, replace if necessary. The Grand Cherokee received a renovation for 2008. Install the knuckle 1 to the vehicle. An alignment is considered essential for efficient steering, good directional stability and to minimize tire wear.
X Drain and refill the front and rear axles. The tool cluster features bright Light-emitting Diode lighting. X Clean and lubricate the brake caliper pins. Place safety floor stands under both lower control arms as far outboard as pos- sible. This coolant offers the best engine cooling without cor- rosion when mixed with 50% distilled water to obtain to obtain a freeze point of -37°C -35°F. Remove the outer tie rod end retaining nut. X X X X X Rotate the tires.