Remove the two screws from the high-mount brake lamp assembly and lift the lamp from the vehicle. Go to the front of the vehicle and push the auxiliary latch, located in the center top of the grille, to the left to release the hood. Wait until the safety belt warning light turns off Approximately one minute. Remove the jumper cable from the ground metal surface. They may cause squeaking, chatter noise, streaking and smearing. Temperature selection: Controls the temperature of the airflow in the vehicle. Failure to replace the belt and retractor assembly could increase the risk of injury in collisions.
This may consist of cornstarch, talcum powder or sodium compounds which may irritate the skin and eyes, but none of the residue is toxic. To reprogram the remote entry transmitters: 1. The window will open fully. For more information, visit your local Ford of Canada dealer or www. Lift the rear end of seat upward and rearward by pushing on the seatback 2 and lifting the seat cushion 3 to disengage the front seat hook and the rear seat latch from the striker.
These may include hot wax treatments used by commercial car washes, water repellent coatings, tree sap, or other organic contamination;. The information provided herein is a reference provided to you at no charge. If your vehicle is not serviced in accordance with flexible fuel vehicles procedures, damage may occur and your warranty may be invalidated. Disconnect the fresh air inlet tube from the radiator support. Please do keep in Mind if a vehicle has some minor dings, scratches, fender, bumper hood that in need to be replaced or painted we do the repairs before selling the vehicles. Steam and scalding liquids released from a hot cooling system can burn you badly.
Only use floor mats that leave the pedal area unobstructed. A double-locking cargo security system, dubbed E-Guard, and new seats designed to improve long-term comfort join the options list. Fold-away mirrors The mirrors can be manually folded forward or backwards for narrow spaces like driving through an automatic car wash or backing out of a garage with the trailer tow mirror. Note that the tire size, load index and speed rating for your vehicle may be different from this example. Cover one of the headlamps so no light hits the wall. Factory installed options such as the Masterack tool storage system and the QuietFlex rack and bin system allow owners to custom-tailor their vans to better suit specific work-related requirements. Children 12 and under should be properly restrained in a rear seating position whenever possible.
The cooling system is under pressure; steam and hot liquid can come out forcefully when the cap is loosened slightly. Rotate the bulb socket counterclockwise and remove. Please take the time to get well acquainted with your vehicle by reading this handbook. Press the control to move the seat forward, backward, up or down. Your results will be most accurate if your filling method is consistent. Ford Motor Company recommends that the fuel system be inspected by an authorized dealer after any collision. If the safety seat is not anchored properly, the risk of a child being injured in a collision greatly increases.
As you move closer to the obstacle, the rate of the tone increases. Follow the same steps to replace any of the bulbs: 1. Ford may change the contents without notice and without incurring obligation. If the tether strap is clipped incorrectly, the child safety seat may not be retained properly in the event of a collision. The horn will chirp once to confirm the procedure is complete. The end of the shoulder belt must be clipped in order to keep it from striking anything during vehicle operation. Remove the four screws and the retaining ring.
Note: In the illustration, the vehicle on the bottom is used to designate the assisting boosting battery. The front doors are unlocked and the cargo doors remain double-locked. Pull and hold the steering wheel release control toward you. If you need to arrange roadside assistance for yourself, Ford Motor Company will reimburse a reasonable amount for towing to the nearest dealership within 35 miles 56 km. Options include a 255-horsepower 5.
We buy most of are vehicles from lease return 75% of the time the lease companies have fixed the issues. These are: gain setting, output bar graph, and trailer connectivity status. The panel vans make wonderful conversion projects and come with a long list of optional fittings to make the job easier for the contractor. With the vehicle locked, unlocking can be switched between two step and one step door unlocking by pressing and holding both the buttons simultaneously on the remote entry transmitter for approximately four seconds and release. It is intended for temporary use only. In addition to the horizontal line marked in step 2, a pair of vertical lines 5 must be marked at the center line of the headlamps on the wall or screen.