Failure to replace the belt and retractor assembly could increase the risk of injury in collisions. Routine maintenance of the air bag is not required. To make sure your tires wear evenly and last longer, rotate them as indicated in the scheduled maintenance guide. The fuel cap may not have been properly installed and securely tightened. Apply the brake and shift into Neutral. Away from home If you own a Ford or Mercury vehicle and are away from home when your vehicle needs service, or if you need more help than the dealership could provide, after following the steps described above, contact the Ford Customer Relationship Center to find an authorized dealership to help you. Select: Use with Bass, Treble, Balance and Fade controls to adjust levels.
The bumper has two bolts… The error code inidicates one of two things. The foglamps can be turned on only when the headlamp control is in the position and the high beams are not. Make sure the seat is latched to the floor. Release the control to disengage rewind mode. Remove the two screws and lamp assembly from vehicle. To fasten, grasp the tongue, and with a continuous motion, pull out enough webbing to buckle the tongue into the correct buckle.
Engine oil filler cap 3. Ford or Mercury vehicles customers call 1-800-241-3673; Lincoln vehicle customers call 1—800—521—4140. Drying can be improved by moving your vehicle slowly while applying light pressure on the brake pedal. Cassette door: Insert the cassette with the opening to the right. In very cold weather, do not fill the reservoir completely. Do not leave the vehicle unattended with the transfer case in N Neutral position. Check the fuel system for leaks.
Check the coolant and coolant level. Rotate the bulb socket counterclockwise and remove it from the lamp assembly. The front passenger and rear seat outboard safety belts have two types of locking modes described below: Safety belt warning light and indicator chime The seat belt warning light illuminates in the instrument cluster and a. Do not place objects on top of the instrument panel, as these objects may become projectiles in a collision or sudden stop. Turn the wrench counterclockwise until tire is lowered to the ground making sure the other end of the wrench does not scuff kick plate, the tire can be slid rearward and the cable is slightly slack. If the parking brake is fully released, but the brake warning lamp remains illuminated, the brakes may not be working properly.
Do not rock the vehicle if the engine is not at normal operating temperature or damage to the transmission may occur. Tape: Press to start tape play. Suitable jump leads for this purpose can be obtained from your dealer. Remove the top bolt on the plastic pipe. Refer to Adding engine coolant, in the Maintenance and Care chapter. Doing so will produce excessive noise, increase tire wear and may damage drive components.
The tires may fail and injure a passenger or bystander. Push and hold for three swipes with wash. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company. Lift the battery with the battery carrier or with your hands on opposite corners. When starting a vehicle with a manual transmission, make sure the parking brake is set, press the clutch pedal to the floor and put the gearshift in N Neutral. To exit the 3rd row seat, pull the red access control lever up releasing the seat from the floor and rotate the seat up towards the front seat.
To operate the feature: 1. The use of tire sealants may also affect your tire pressure monitoring system if equipped. Please take the time to get well acquainted with your vehicle by reading this handbook. Never let a passenger hold a child on his or her lap while the vehicle is moving. Ford may change the contents without notice and without incurring obligation. If the outside temperature is about 6°C 43°F or higher, the air conditioner will automatically dehumidify the air to reduce fogging.
Locate the lever on the side of the seatback. See your dealer or a qualified service technician. For added customer comfort, the system will allow some airflow through the floor ducts in this mode. Check the engine oil and coolant level refer to Adding engine oil and Adding coolant in the Maintenance and care chapter. Following this, the outside temperature display will return to the window.
If you ever smell exhaust fumes of any kind inside your vehicle, have your dealer inspect and fix your vehicle immediately. When ethanol is used in the making of motor fuels, a small amount of a bad tasting chemical is added to discourage beverage use. Engine Engines are more efficient when they are clean because grease and dirt buildup keep the engine warmer than normal. To adjust the headlamps: 1. If your vehicle is equipped with a tire pressure monitoring system, refer to Tire Pressure Monitoring System if equipped in the Maintenance and care section for important information.
Enter your personal 5 digit code. Transmission operates in gears one through five. Your spare tire and tools can be found in the following locations: Tool Location Spare Tire. Pull the lever towards you to deactivate. Turn the lug wrench clockwise until the tire is in its original position. Production sequence number Engine number The engine number the last eight numbers of the vehicle identification number is stamped on the engine block, transmission, frame and transfer case if equipped. The decisions of the Board are binding on Ford and, in some cases, on the dealer but not on consumers who are free to pursue other remedies available to them under state or federal law.